Vetnews | Junie 2026 20 « BACK TO CONTENTS Scalable DICOM 3D-printed phantoms.... <<< 19 While Rigid 10 K resin exhibited a modulus range of 7,500–11,000 MPa (closely approximating the mechanical behaviour of mammalian bone), Draft resin was ultimately selected due to its improved durability during fabrication. This material provided a practical compromise between mechanical rigidity and fracture resistance, addressing the fragility observed in initial Rigid 10 K prints. For the gels, Humimic Gel 0 and Gel 5 demonstrated approximate stiffness values of approximately 0.0139 MPa and 0.0021 MPa, respectively. Article Figure 7 . (a) Casting the final soft tissue layer (20% scale model) using Humimic Gel 5, poured to fill the remaining mould volume; (b) Heat polishing the exposed top layer to smooth surface imperfections without damaging the skin shell; (c) Superior view of phantom model after heat polish; (d) Colour overlay of the distinct phantom components. The Gel 0-dip-coated skeletal structure (magenta) is embedded within the Humimic Gel 5 soft-tissue layer (yellow) and enclosed by the compliant outer shell (blue) Figure 8 . (Left) Compressive stress–strain hysteresis loops of Humimic Medical Gel to 25% Strain for three continuous loading cycles; (Right) Corresponding linear fit with 95% confidence and prediction bands Measurement Gel 0 Gel 1 Gel 2 Gel 3 Gel 4 Gel 5 E (kPa) 13.9 ± 0.13 11.3 ± 0.14 6.37 ± 0.03 3.35 ± 0.04 2.69 ± 0.01 2.13 ± 0.02 Pearson’s r 0.995 0.9992 0.998 0.99 0.999 0.994 Coefficient of Determination (R2) 0.99 0.985 0.996 0.98 0.997 0.988 Laughlin et al.7E (kPa) 92.02 ± 16 49.05 ± 5 36.57 ± 7 25.55 ± 5 17.02 ± 7 Not measured Laughlin et al.7 Reported R2 0.97 0.96 0.98 0.97 0.91 Not measured Humimic Reported E (kPa) 57014 37021 26016 19017 15022 10015 Table 3. Compressive stress–strain elastic loading of Humimic Medical Gel to 25% strain for three continuous loading cycles with linear fit statistics, with comparison to reported values
RkJQdWJsaXNoZXIy OTc5MDU=